Layer actions

Through the layer operation panel, layer transformation, tilt flattening. This feature only supports S3M tile data (*.scp).

Left click the More button after specifying the layer, and select Layer Operation from the pop-up menu, and the Layer Operation Panel will pop up.

Layer operation interface

Layer transformation

Used to set the translation parameters of the layer on which the S3M tile is located to translate the layer as a whole.

Layer transformation
  • Click More -> Layer Operations -> Layer Transformation after the specific layer, and the Layer Transformation Panel pops up.
  • X: If desired, you can set the translation distance in meters along the X axis by entering a numerical value directly and pulling the slider.
  • Y: If desired, you can set the translation distance in meters along the Y axis by entering a numerical value directly and pulling the slider.
  • Z: If desired, you can set the translation distance in meters along the Z axis by entering a numerical value directly and pulling the slider.

Oblique flattening

Use to flatten oblique photographic 3D models within the drawing area of the scene. The procedure is as follows:

  1. Click More -> Layer Actions -> Tilt Flat after a specific layer to pop up the Layer Transformation Panel.
  2. Click Flattening , left mouse click to draw the flattening area in the scene, right mouse click to finish drawing, you can flatten the oblique photography 3D model in the drawing area in the scene.
    3. Tilt data not flattened
  3. The flattening effect is shown below.
    4. planish
  4. Click the Clear button to clear the scene of the oblique photographic 3D model flattening effect.

Excavation

Polygon excavation function, this function is used to excavate the earth surface and terrain in the scene. The procedure is as follows:

  1. Click More -> Layer Operations -> Excavation after the specific layer, and the Excavation panel pops up.
  2. After filling in the underground depth, click Draw, then draw the surface on the terrain and spherical skin, right click End, you can see the excavation results.
  3. If you want to excavate the surface effect, you can fill in the side map, the absolute path of the side map to the corresponding material settings.
    4. Excavation results